DIYAUTOFIXESMANUALS

Diagnostic Trouble Code Database

U1087Severe (Stop & Fix)

SCP (J1850) Invalid or Missing Data for Primary Id

System:Manufacturer Network Communications•Classification:Network (OBD-II Generic)•Severity Impact:Secondary network module dropped off bus.
Direct Technical Definition (Fast Answer)

Code U1087 indicates a diagnostic fault in the Manufacturer Network Communications (SCP (J1850) Invalid or Missing Data for Primary Id). Connect an OBD2 scanner to verify freeze frame data, then test circuit voltage and vacuum connections before replacing components.

Estimated Repair Time30 – 60 minutes
DIY Parts Cost$20 – $70
Shop Repair Quote$220 – $650
Average DIY SavingsSave $200+
The 80/20 Workshop Rule

Inspect the electrical harness and ground connection related to U1087. Clear the code with an OBD2 scanner; if it returns, perform a multimeter resistance check on the primary sensor.

Estimated DIY Cost
$20 – $70
Tools & DIY parts
Dealership Shop Quote
$220 – $650
Labor ($180/hr) + parts
Net Money Saved
Save $200+
In your driveway today

Symptoms Associated with U1087

Drivers typically observe the following symptoms when the ECM flags U1087:

Check Engine Light (MIL) illuminated on instrument cluster
Possible engine performance, hesitation, or emission monitor reset
Failed annual vehicle safety or emissions smog inspection

Common Root Causes & Statistical Probability Matrix

Statistical breakdown of what triggers this code based on automotive repair shop data.

Worn, contaminated, or defective SCP (J1850) Invalid or Missing Data for Primary Id component
High ProbabilityDifficulty: Moderate
Relative Frequency: 75%Estimated Parts Cost: Low
Damaged, loose, or corroded wiring harness connector pins
Medium ProbabilityDifficulty: Easy
Relative Frequency: 45%Estimated Parts Cost: Low
Underlying vacuum leak, blown fuse, or poor chassis ground
Low ProbabilityDifficulty: Easy
Relative Frequency: 20%Estimated Parts Cost: Low

Step-by-Step Diagnostic & Repair Procedure

Follow this logical order to isolate and repair U1087 before spending money on costly parts.

Checklist Progress: 0 of 3 steps complete

Step 1: Scan and Record Freeze Frame Data

Connect an OBD2 scanner, record engine RPM, coolant temp, and secondary DTCs associated with U1087.

Step 2: Visual Inspection

Inspect wiring harnesses, pins, and vacuum lines related to the Manufacturer Network Communications for chafing, oil contamination, or burn marks.

Step 3: Multimeter / Component Verification

Measure 12V reference power, ground continuity, and signal voltage against factory service manual specifications for U1087.

Frequently Asked Questions About U1087

Severity is rated as Severe. Secondary network module dropped off bus.