How do I clear the P0828 trouble code?

Repair the root cause, clear the DTC with an OBD2 scan tool, and complete a 15-minute drive cycle (stop-and-go plus 55 MPH cruise) to verify the readiness monitor sets.

P0828Severe (Stop & Fix)

Up and Down Shift Switch Circuit High

System:Transmission & Drivetrain•Classification:Powertrain (OBD-II Generic)•Severity Impact:Transmission control solenoid or clutch circuit error. Avoid towing or high loads.

Direct Technical Definition (Fast Answer)

Code P0828 indicates a diagnostic fault in the Transmission & Drivetrain (Up and Down Shift Switch Circuit High). Connect an OBD2 scanner to verify freeze frame data, then test circuit voltage and vacuum connections before replacing components.

Estimated Repair Time30 – 60 minutes

DIY Parts Cost$35 – $110

Shop Repair Quote$280 – $850

Average DIY SavingsSave $200+

The 80/20 Workshop Rule

Inspect the electrical harness and ground connection related to P0828. Clear the code with an OBD2 scanner; if it returns, perform a multimeter resistance check on the primary sensor.

Estimated DIY Cost

$35 – $110

Tools & DIY parts

Dealership Shop Quote

$280 – $850

Labor ($180/hr) + parts

Net Money Saved

Save $200+

In your driveway today

Symptoms Associated with P0828

Drivers typically observe the following symptoms when the ECM flags P0828:

Check Engine Light (MIL) illuminated on instrument cluster

Possible engine performance, hesitation, or emission monitor reset

Failed annual vehicle safety or emissions smog inspection

Common Root Causes & Statistical Probability Matrix

Statistical breakdown of what triggers this code based on automotive repair shop data.

Worn, contaminated, or defective Up and Down Shift Switch Circuit High component

High ProbabilityDifficulty: Moderate

Relative Frequency: 75%Estimated Parts Cost: Low

Damaged, loose, or corroded wiring harness connector pins

Medium ProbabilityDifficulty: Easy

Relative Frequency: 45%Estimated Parts Cost: Low

Underlying vacuum leak, blown fuse, or poor chassis ground

Low ProbabilityDifficulty: Easy

Relative Frequency: 20%Estimated Parts Cost: Low

Step-by-Step Diagnostic & Repair Procedure

Follow this logical order to isolate and repair P0828 before spending money on costly parts.

Checklist Progress: 0 of 3 steps complete

Step 1: Scan and Record Freeze Frame Data

Connect an OBD2 scanner, record engine RPM, coolant temp, and secondary DTCs associated with P0828.

Step 2: Visual Inspection

Inspect wiring harnesses, pins, and vacuum lines related to the Transmission & Drivetrain for chafing, oil contamination, or burn marks.

Step 3: Multimeter / Component Verification

Measure 12V reference power, ground continuity, and signal voltage against factory service manual specifications for P0828.

Frequently Asked Questions About P0828

Severity is rated as Severe. Transmission control solenoid or clutch circuit error. Avoid towing or high loads.